User`s guide

L1 Controller Commands
007-3938-003 83
• Use reboot_l1 raw <exp> to boot the L1 controller flash image at the flash image
address listed for <exp>.
Used on all bricks.
reset
Use the reset command to perform a reset of the system. After the system controller
receives a reset command, it sets various control and status signals back to their default
values, and reboots the operating system. Example 3-61 shows sample output.
Example 3-61 reset Command Output
001c07-L1>reset
001c07-L1>
Used on all bricks.
router
Use the following router command set to view and set router types, to set routers in
different modes for reasons such as service, and to enable router ports. This command set
is valid only for R-bricks and NUMAlink modules:
• router
• router meta
• router repeater
• router ordinary
• router 6 port
• router 8 port
• router 8 port <str> <str> <str> <str>
• router service <str> <str> <str> <str>
• router service off
• router spare