User`s guide

82 007-3938-003

3: L1 and L2 Controller Commands

Example 3-59 power check Command Output

001c07-L1>power check

power appears on

Use power <up|down> to power up or power down all of the power supplies in a brick

or system. Example 3-60 shows sample output.

Example 3-60 power up Command Output

001c07-L1>power up

001c07-L1>

Used on all bricks.

reboot_l1

The following reboot_l1 command set reboots the L1 controller.

• reboot_l1

• reboot_l1 <a|b>

• reboot_l1 <current|old|new|other>

• reboot_l1 addr <exp>

• reboot_l1 raw <exp>

Use the other commands in this set as follows:

• Use reboot_l1 to reboot the L1 controller using the newest ﬁrmware image

(ﬁrmware image A or ﬁrmware image B).

• Use reboot_l1 <a|b> to reboot the L1 controller using the speciﬁed ﬁrmware

image (A or B).

• Use reboot_l1 <current|old|new|other> to reboot the L1 controller using

either the current, older, newer, or other (non-current) ﬂash image.

• Use reboot_l1 addr <exp> to validate and boot the L1 controller ﬂash image at

the ﬂash image address listed for <exp>.