User`s guide

6 007-5630-001

1: Introduction and Overview

Caution: The power supply cords are used as the main disconnect device, ensure that the

sockets/outlets are located or installed near the equipment and are easily accessible.

The system starts and displays a welcome message. After that, a series of power-on self-test

(POST) messages appear. The POST messages indicate whether or not the system is running

correctly. If the system does not turn on or boot after pressing the enable power switch, see the

next section for possible causes.

Figure 1-3 Pushing the Enable Power Switch

USB-2-A

USB-2-B

VGA-B

SERIAL-B

GIGE-0-A

GIGE-0-B

GIGE-1-A

GIGE-1-B

DVI-3-A

DVI-3-B

DVI-2-A

DVI-2-B

DVI-1-A

DVI-1-B

DVI-0-A

DVI-0-B

SERIAL-A

VGA-A

USB-1-A

USB-1-B

USB-0-A

USB-0-B

3D-A

3D-B