Specifications

56
Chapter 2: Installing and Removing the CPU and Memory
Removing Memory
If you have not already done so, power off the workstation, wait 5 minutes after
powering off the workstation to allow the heat sinks to cool, attach the wriststrap, and
removethe system module fromthe chassis. See “Preparingthe Workstation to Remove
and Install a CPU and Memory” on page 38 and follow the instructions through
removing the system module. Then return to this page.
Figure 2-18 Locating DIMMs on the System Module
Bank 1
DIMMs
Processor
System module
Bank 2
Bank 3
Bank 4
Compression connector
do not touch gold plate