Specifications

48
Chapter 2: Installing and Removing the CPU and Memory
Installing and Removing a CPU/Processor
Your OCTANE workstation uses either a single or a dual CPU (processor). The
installation procedure is the same for a single or dual processor of any speed.
Removing a CPU
Figure 2-11 Removing the Single Processor
To remove a CPU, you must first power off the workstation, wait 5 minutes to allow the
heat sinksto cool,attach the wriststrap, and remove the systemmodule. If you have not
already done so, go to “Preparing the Workstation to Remove and Install a CPU and
Memory” onpage 38 and follow the instructions through removing the system module.
Then return to this section and follow these instructions:
1. Loosen the four captive Phillips screws holding the CPU in place. The dual
processor has six screws.
Single processor