Specifications

Removing the System Module
43
2. Loosen the captive screws that hold the sliding handles to the OCTANE
workstation. See Figure 2-5.
Figure 2-6 Locating the Compression Connectors
Look for the two compression connectors when you take the system module out of
the chassis, and do not touch them. They are on the back ofthe system module, and
connect to the chassis when the system module is installed in the workstation.
Caution: The gold bristled pad on the compression connectors on the back of the
system module is very delicate and easily damaged. Before you remove the system
module, read Appendix B, “Care and Cleaning of the Compression Connector.”
Bristled pad