Specifications

38
Chapter 2: Installing and Removing the CPU and Memory
Preparing the Workstation to Remove and Install a CPU and Memory
Figure 2-1 Powering Off the OCTANE Workstation
To prepare the workstation to install or remove a CPU or memory, follow these steps:
1. Open the cover and push the power button to power off the OCTANE workstation.
(Step A)
2. Unplug the power cord from the electrical outlet and from the OCTANE
workstation. (Step B)
3. Press the power switch on the monitor. (Step C)
4. Wait 5 minutes before removing the system module.
Warning: The heat sinks on the CPU and system module become very hot. Wait 5
minutes after powering off the OCTANE workstation before you remove the
system module. Test before touching the CPU or heat sinks.
Power button
Power cord
Power switch
A
B
C