Specifications

Enabling the System Maintenance Password

275

3. Place the jumper on the left and middle pins within the rectangle. The password is

now disabled.

4. Return to Chapter 2, “Replacing the System Module” on page 59 and follow the

instructions through powering on the OCTANE workstation.

Enabling the System Maintenance Password

After you have powered on the OCTANE workstation, you can choose another system

maintenance password.

1. Power on the OCTANE workstation, if you have not already done so.

2. Go to the Toolchest > Help > InfoSearch > Online Books > SGI End User > Personal

System Administration Guide. Go to the section, “Creating, Changing and Deleting

Passwords” in Chapter 5. Follow the instructions for creating or changing a

password. Then return here for instructions on moving the jumper.

3. Go to Chapter 2, “Preparing the Workstation to Remove and Install a CPU and

Memory” on page 38, and follow the instructions through “Removing the System

Module.” After the system module is removed, return here for instructions on

enabling the password.

Note: The jumper is a small plastic cap that resides near the CPU. The jumper is on

theleftsideofthe3-pinconﬁgurationbecausethepasswordwasdisabledbymoving

the jumper to the left. To enable the password, you must move the jumper to the

right. Go to the next step for instructions on moving the jumper to the right.