Specifications

256
Chapter 7: Installing and Removing Drives and Front Module Parts
You are finished replacing the plastic base and are ready to replace the bezel.
Replacing the Bezel
Figure 7-36 Replacing the Bezel
1. Replace the bezel.
■ Lower the bezel into the lower edge of the chassis.
■ Hook the bezel in place.
■ Rotate the bezel back and into closed position.
You can hear the latches snap into place when the bezel is fully installed.
To replace the lockbar, go to the next step. Otherwise, skip to “Powering On the
OCTANE Workstation” on page 258.