Specifications

252
Chapter 7: Installing and Removing Drives and Front Module Parts
Removing and Installing the Plastic Base
To remove the plastic base, you need to shut down the system, remove the bezel, and
remove the top plastic cover.
To shut down the system, go to “Shutting Down and Powering Off the System” on
page 218 and follow the steps through removing the bezel.
Thengoto“RemovingandInstallingthePlastics:TopandBase”onpage 250,thesection
directly before these instructions, and remove the plastic top cover. Then return to this
section and begin with step 1.
Figure 7-32 Locating the Release Slots
1. On the base of theworkstation, locatethe plastictab located in frontof the metal tab
with an arrow.
Chassis
Plastic
release tab