Specifications

250
Chapter 7: Installing and Removing Drives and Front Module Parts
Removing and Installing the Plastics: Top and Base
To remove the plastics, top or base, you must shut down the system and remove the
bezel. Go to “Shutting Down and Powering Off the System” on page 218 and follow the
instructions through removing the bezel. Then return to this section for instructions on
removing the plastics.
Figure 7-30 Releasing the Plastic Top Cover
1. Locate the two areas to press to release the top cover.
2. Press on these areas and hold.
3. While pressing inward on both areas, pull the cover toward the front. The cover
should slideforward. If the coverdoes not slide forward,press harder torelease the
catches, and slide the cover forward.