Specifications

244
Chapter 7: Installing and Removing Drives and Front Module Parts
Installing the Frontplane Module
Figure 7-26 Tightening the Captive Screws on the Frontplane Module
If youhave notalreadydone so, go to “Removing and Installing the Frontplane Module
and System Identification Module” on page 237 and follow the steps through removing
the frontplane module and system identification module. Then return here. You are
ready to install the new frontplane module in the OCTANE workstation.
1. Grasp the replacement frontplane module by the metal frame on the edge of the
front plane.
2. Lift the frontplane module into place and gently insert it into the OCTANE
workstation.
3. Tighten the six captive screws.
4. Replace the system drive and any option drives.
5. Replace the light module.