Specifications

Removing and Installing the Frontplane Module and System Identification Module
243
Removing the System Identification Module
Figure 7-25 Sliding Out the System Identification Module
Remove the system identification module only when replacing the frontplane module.
1. Remove the system identification module.
■ Lift up on the metal retaining clip.
■ Slide the system identification module to the side and out.
2. Place the system identification module on the new frontplane.
■ Lift up on the retaining clip.
■ Slide the system identification module under the clip.
You are ready to install the frontplane. Go to the next section for instructions on
installing the frontplane.