Specifications

242
Chapter 7: Installing and Removing Drives and Front Module Parts
Figure 7-24 Placing the Frontplane Module Face Down on a Clean Surface
5. Gently place it face down, on a clean, antistatic surface.
6. To adjust the position of the frontplane module, handle it by the metal frame to
avoid damaging components.
If you are replacingthe frontplane module witha new frontplane module,go tothe next
section. You must remove the system identification module from the old frontplane
module and place it on the new frontplane module.
If youremoved the frontplane module as part of thetask of replacing the system fan, go
to “Removing and Installing the System Fan” on page 245 for further instructions.
System identification
module
Metal frame
Drive bays
System fan