Specifications

Removing and Installing the Frontplane Module and System Identification Module
241
Removing the Frontplane Module
Figure 7-23 Locating the Screws Holding the Frontplane Module to the Chassis
1. If you have not already done so, go to “Removing and Installing the Frontplane
Module andSystem IdentificationModule” onpage 237 andfollow the instructions
before you begin with this section.
2. Place an antistatic bag on a clean, antistatic surface. Your desktop works well.
3. Loosen the six captive screws holding the frontplane module tothe chassis until the
screws are loose in their sockets.
4. Place your hand inside the drive bay, and lift the frontplane module out of the
chassis.
Caution: Thefrontplanemoduleislargeandunwieldy.Steadyitwithyoufreehand
on the edge of the frame as you remove it from the chassis.