Specifications

240
Chapter 7: Installing and Removing Drives and Front Module Parts
■ Disconnect the power supply from the chassis by unscrewing the captive
screws and pulling the power supply an inch or two from the chassis, or
remove it. (See Chapter 3 for help disconnecting or removing this module.)
Then return to this section.
■ Disconnect the XIO module from the chassis by unscrewing the captive screws
and pulling the XIO module an inch or two from the chassis, or remove it. (See
Chapter 5 for help disconnecting or removing this module.) Then return to this
section.
3. On the front of the OCTANE workstation:
■ Remove the system drive and any option drives. Go to “Replacing the System
Drive” on page 231 and “Removing Internal Option Drives” on page 228 to
removethe system drive and any option drives that are installed.Then return to
this section.
■ Remove the light module. Go to “Replacing the Light Module” on page 235 for
instructions on removing the light module. Then return to this section.
You are ready to begin removing the frontplane module.