Specifications

Removing and Installing the Frontplane Module and System Identification Module
237
Figure 7-21 Inserting the Light Module
4. Insert the new light module.
■ Align the two hollow plastic pins on the module with the two solid metal pins
on the sheet metal cap.
■ Slide the module onto the sheet-metal face until the module snaps into place.
Make sure both sides snap firmly into place.
You have finished the light module installation and are ready to replace the bezel. Goto
“Replacing the Bezel” on page 256and follow theinstructions through powering on the
OCTANE workstation.
Removing and Installing the Frontplane Module and System Identification Module
Caution: The components on the frontplane module are extremely sensitive to static
electricity; you must wear the wrist strap while working with the frontplane module.
Light module