Specifications

Installing and Removing Internal Drives
229
Figure 7-12 Sliding Out the Option Drive
2. Pull the drive directly toward you to remove it from the drive bay.
To install a drive in the option drive bay, go to “Installing an Internal Option Drive” on
page 223.
Toleave the drive bay empty,replacetheblank panel beforereplacingthebezel,goto the
next section.
Replacing a Blank Panel
If you removed a secondary drive and do not intend to replace it, you must inform the
system that the drive is no longer there and replace the blank panel.
1. Remove the bezel. See “Removing the Bezel” on page 219. Then return here for
instructions on replacing the blank panel.
2. Place the bezel face down on the flat surface with the door closed. (Take care to
place the bezel on a surface that does not scratch or mar the surface.)
3. Locate the appropriate opening for the blank panel, opposite the empty drive bay,
and place the blank panel in it.
Option drive