Specifications

188
Chapter 6: Installing and Removing External Devices
Setting the SCSI Address on the External Device
To set the SCSI address on the external device, locate a switch, button, dial, or jumpers
andmanuallyset the address.Usetheaddressyouchoseinstep4of the previoussection.
Ifthedevicehasapushbutton,switch,ordialontheback,followthestepsbelow.Ifthere
is no switch or dial on the device, see the instructions included with the device.
Figure 6-1 Manually Setting the SCSI Address
1. Take the device out of its box and locate the push-button, switch, or address dial. It
may be on the rear or bottom of the device. An example is shown in Figure 6-1.
2. Use a small screwdriver or pencil tipto set the dial or push the buttonsto assign the
address number you chose in step 5 of the previous section.
Caution: Do not assign number 0. This number is reserved for the SCSI controller.