Specifications

174
Chapter 5: Installing and Removing XIO Graphics and Option Boards
Figure 5-40 Replacing the XIO Module
Follow these instructions to install the XIO module:
1. Replace the XIO module in the OCTANE workstation by sliding the XIO module
into guides on the top and bottom of the workstation.
2. Before you insert the XIO module, make sure the handle portion protrudes in a
locked position from the I/O panels, as shown in Figure 5-40.
If the handles are flush with the I/O panels, the XIO module will stop during
insertion. Pull out the handles until the sliding portionof the XIO modulelooks like
Figure 5-40, and then continue inserting the XIO module into the chassis.
XIO module
Graphics
board,
upper left
Lower
left
Lower
right
Upper
right
B
C
A
D