Specifications

170
Chapter 5: Installing and Removing XIO Graphics and Option Boards
Removing a Texture Memory Option Board From the Graphics Board
Ifyouhavenotalreadydoneso,see“PreparingtheWorkstationtoInstallorRemoveXIO
Boards” on page 134 and follow the instructions through removing the XIO module.
A single texture memory option board is installed on the OCTANE/SI graphics board.
Two texture memory option boards are installed on the OCTANE/MXI graphics board.
Use the same process to remove texture memory option boards from the OCTANE/SI
and OCTANE/MXI graphics board.
If you are removing texture memory option boards from the OCTANE/MXI graphics
board, begin with the texture memory option board closest to slot A.
Figure 5-36 Removing the Screw Holding the Texture Memory Option Board to the I/O Panel
1. Remove the nylon screw from the I/O panel.
Connectors
on the underside
of the texture
memory board
UP