Specifications

Placing a Texture Memory Option Board on the Graphics Board
169
Figure 5-35 Inserting the Nylon Screw
5. Place and tighten the nylon screw that came with the texture memory board
through the hole in the I/O panel and into the hole on the texture memory option
board as shown in Figure 5-35.
Caution: Do not use a metal screw; your board does not perform properly. Order
another nylon screw from your authorized service provider if this screw is lost or
damaged.
IfyouareinstallingtexturememoryboardsontheOCTANE/SSIboard,repeattheabove
steps to install the second board. (After the texture memory boards are installed, the
OCTANE/SSI graphics board is known as the OCTANE/MXI graphics board.)
You are finished installing the texture memory option board and are ready to install the
XIO module. Go to “Installing the XIO Module” on page 173.
Connectors
on the underside
of the texture
memory board
UP