Specifications

Installing a Graphics Board, Option Board, or Blank Panel
163
Figure 5-29 Attaching the Screw to Anchor the Cable Guard
5. Place the screw from the graphics board through the hook on the cable guard and
the graphics board, and into the standoff on the XIO module. Then tighten it.
If you received a screw with the cable guard, use this longer screw instead of the
screw you just removed from the graphics board.
6. You have finished installing the flex cables and cable guard.
7. Remove the caps from all XIO compression connectors. Keep the caps to protect the
compression connector should you ever remove any XIO board.
8. Go to “Installing the XIO Module” on page 173.
Graphics board
A
Cable guard
Screw
UP
Option board with flex cables