Specifications

Installing a Graphics Board, Option Board, or Blank Panel
155
Figure 5-22 Replacing the Screws
3. Place the graphics board, option board, or blank panel on the standoffs.
Some option boards must be placed in designated slots. Always check your option
boardinstallation manualfor information about board placement orother pertinent
information.
Caution: Some option boards with three flex cables use extra-long screws and
possibly a spacer that fits over the screw closest to the flex cables. Use these
extra-long screws only with the option board. Using extra-long screws with a
graphics board or blank panel damages the standoffs.
See step 8 in “Removing a Graphics Board, Option Board, or Blank Panel With No
Baffle,” for a listing of the number and types of screws used by option boards,
graphics boards, and blank panels.
4. Replace the screws, tightening the board or panel to the standoffs.
Standoff
Graphics board
Screws
Blank panel
Cap on
XIO compression
connector
Slot D
Slot A
UP