Specifications

Removing the XIO Module
141
Figure 5-9 Placing the XIO Module on Its Side
The handle area protrudes when the XIO module is out of the chassis. When the
handle protrudes, the identification slots for the XIO boards, (D and A on one side,
B and C on the other), are visible. See Figure 5-9.
Note: Do not push onthe handlearea afteryou have removed the XIOmodule. The
XIO module locks to the workstation only if the handle area is protruding.
4. Place the XIO module on a flat, antistatic surface. An empty antistatic bag on your
desk works well.
Graphics board
Blank panel
I/O panel
XIO module
Slot D
Cap
Slot A
UP