Specifications

List of Figures
xv
Figure 5-10 Placing a Cap on the XIO Compression Connector 142
Figure 5-11 Identifying the Slots Used by an XIO Board 143
Figure 5-12 Placing the Cap on the XIO Compression Connector 144
Figure 5-13 Removing the Standoff Screw 145
Figure 5-14 Sliding the Cable Guard Beneath the I/O Panel 146
Figure 5-15 Removing the Cable Guard 147
Figure 5-16 Replacing the Graphics Board Screw 148
Figure 5-17 Releasing the Flex Cables From the Graphics Board 149
Figure 5-18 Removing the Flex Cables From the Graphics Board 150
Figure 5-19 Removing the Screws From the XIO Board 151
Figure 5-20 Removing the Graphics Board 152
Figure 5-21 Removing the Baffle 153
Figure 5-22 Replacing the Screws 155
Figure 5-23 Attaching the Option Board Flex Cables to the Graphics Board 157
Figure 5-24 Attaching the Flex Cables to the Graphics Board 158
Figure 5-25 Identifying Parts for the Cable Guard Installation 159
Figure 5-26 Removing the Screw From the Graphics Board 160
Figure 5-27 Sliding the Cable Guard Under the I/O Panels 161
Figure 5-28 Sliding the Cable Guard Behind the Standoff 162
Figure 5-29 Attaching the Screw to Anchor the Cable Guard 163
Figure 5-30 Installing the Baffle on Two Side-by-Side Blank Panels 164
Figure 5-31 Removing the Cap From the XIO Compression Connector 165
Figure 5-32 Locating the Connectors for the Texture Memory Option Board 166
Figure 5-33 Locating the Connectors for the Texture Memory Option Board on the
OCTANE/SSI Graphics Board 167
Figure 5-34 Installing the Texture Memory Option Board on the OCTANE/SI
Graphics Board 168
Figure 5-35 Inserting the Nylon Screw 169
Figure 5-36 Removing theScrew Holdingthe Texture Memory Option Boardto the
I/O Panel 170
Figure 5-37 Releasing the Texture Memory Option Board From the
Graphics Board 171
Figure 5-38 Removing the Texture Memory Option Board 172