Specifications

xii
List of Figures
Figure 1-28 Shutting Down the System Notifier 33
Figure 1-29 Shutting Down the System Caution Notifier 33
Figure 1-30 System Shutdown Notifier 34
Figure 1-31 Okay to Power Off Notifier 34
Figure 1-32 Starting Up the System Notifier 34
Figure 2-1 Powering Off the OCTANE Workstation 38
Figure 2-2 Removing the Lockbar 39
Figure 2-3 Removing the Cables From the System Module 40
Figure 2-4 Attaching the Wrist Strap to the Chassis 41
Figure 2-5 Removing the System Module Screws 42
Figure 2-6 Locating the Compression Connectors 43
Figure 2-7 Releasing the System Module From the Frontplane 44
Figure 2-8 Removing the System Module From the Chassis 45
Figure 2-9 Locating the Compression Connectors 46
Figure 2-10 Placing the Compression Cap on the Compression Connector 47
Figure 2-11 Removing the Single Processor 48
Figure 2-12 Lifting the Single Processor From the System Module 49
Figure 2-13 Lifting the Dual Processor From the System Module 50
Figure 2-14 Viewing the Connectors on the Underside of the CPUs 51
Figure 2-15 Installing a Single Processor 52
Figure 2-16 Installing the Dual Processor 53
Figure 2-17 Identifying DIMM Sockets and DIMM Banks 55
Figure 2-18 Locating DIMMs on the System Module 56
Figure 2-19 Removing a DIMM 57
Figure 2-20 Locating the Notches on a DIMM 58
Figure 2-21 Removing the Compression Connector Cap 59
Figure 2-22 Supporting the System Module 60
Figure 2-23 Replacing the System Module in the OCTANE Workstation 61
Figure 2-24 Locking the System Module to the Frontplane 62
Figure 2-25 Replacing the System Module Screws 63
Figure 2-26 Replacing Cables to the System Module 64
Figure 2-27 Powering On the OCTANE Workstation 65
Figure 2-28 Installing the Lockbar 66