User`s guide

SGI Gigabit Ethernet Adapter For Windows NT
Troubleshooting
4-3
7. Review the test results.
The test result from the previous example could look like this:
Both the internal and external loopback example tests show 1000 packets successfully received
with 0 errors detected, indicating that the adapter hardware is functioning properly.
If the adapter does not perform as expected, try reinstalling the adapter or moving it to a differ-
ent slot or to a different system, then run the
TTP
tests again. If the card still fails, contact Cus-
tomer Support.
DOS/4GW Protected Mode Run-time Version 1.97
Copyright (c) Rational Systems, Inc. 1990-1994
Development and Diagnostic Test Program () v1.0.5
PCI bios found. v0.16.
HW Mech #1 supported
Number of PCI buses: 1
SGI #0 found in PCI bus 0.
SGI #1 found in PCI bus 0.
2 SGI card(s) detected
Current card set to bus 0 SGI #1.
internal Loopback Test
pkts:0 secs:0pkts:48 secs:1pkts:144 secs:2pkts:240
secs:3pkts:320 secs:4pkts:416 secs:5pkts:512 secs:6pkts:592
secs:7pkts:688 secs:8pkts:784 secs:9pkts:864 secs:10pkts:960
secs:11 1000 packets transmitted sucessfully
1000 packets received sucessfully
0 errors detected
external Loopback Test
pkts:0 secs:0pkts:96 secs:1pkts:192 secs:2pkts:288
secs:3pkts:368 secs:4pkts:464 secs:5pkts:544 secs:6pkts:640
secs:7pkts:736 secs:8pkts:816 secs:9pkts:912 secs:10 1000 pack-
ets transmitted sucessfully
1000 packets received sucessfully
0 errors detected
>