User`s guide

SGI Gigabit Ethernet Adapter For Windows NT

Part Number: 860-0231-001, Revision A.

This document is protected by copyright and distributed under licenses restricting its use, copying,

distribution, and decompilation. No part of this document may be reproduced in any form by any means

without prior written authorization of SGI. Documentation is provided “as is” without warranty of any

kind, either express or implied, including any kind of implied or express warranty of non-infringement or

the implied warranties of merchantability or fitness for a particular purpose.

U.S. Government End Users: This document is provided with a “commercial item” as defined by FAR

2.101 (Oct 1995) and contains “commercial technical data” and “commercial software documentation” as

those terms are used in FAR 12.211-12.212 (Oct 1995). Government End Users are authorized to use this

documentation only in accordance with those rights and restrictions set forth herein, consistent with FAR

12.211- 12.212 (Oct 1995), DFARS 227.7202 (JUN 1995) and DFARS 252.227-7015 (Nov 1995).

SGI reserves the right to change any products described herein at any time, and without notice. SGI

assumes no responsibility or liability arising from the use of products described herein, except as expressly

agreed to in writing by SGI. The use and purchase of this product does not convey a license under any

patent rights, trademark rights, or any other intellectual property rights of SGI.

SGI and the SGI logo are trademarks of Silicon Graphics Inc. in the United States and certain other

countries. Microsoft and Windows NT are registered trademarks of Microsoft Corporation in the United

States and in other countries. Any other trademarks appearing in this manual are owned by their respective

companies.

Regulatory Compliance

FCC Class A Notice:

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: 1. This device may not cause harmful interference. 2. This device must accept

any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference in which case the user will be required to correct

the interference at his own expense.

Do not make mechanical or electrical modifications to the equipment.

VCCI Class 1.

The equipment is Type 1 Data Processing Equipment and is intended for use in commercial

and industrial districts. It has been tested and found to comply with VCCI technical requirements for the

purpose of protection against electronic interference. When used in residential districts or their peripheral

areas, radio, and TV receiver units may be subject to radio interference. The operation should be done in

accordance with the Instruction Manual.

CE Notice.

The CE mark on this equipment indicates that this equipment meets or exceeds the following

technical standards: EN50082-1, EN55022, EN60555-2, EN61000-4-1, EN61000-4-2, EN61000-4-3,

EN61000-4-4, and EN61000-4-5.