User`s guide

SGI Gigabit Ethernet Adapter For Windows NT
Installing the Adapter Hardware
2-3
SGI Gi
g
abit Ethernet Adapter Installation
To install a SGI Gigabit Ethernet Adapter in your system, perform the following procedure.
1. Observe all precautions and pre-installation instructions on page 2-2.
Before installing the adapter, ensure the system power is OFF
,
and proper electrical grounding
procedures have been followed.
2. Remove the server cover, and select any empty PCI slot.
If you do not know how to identify a PCI slot, refer to your server documentation.
3. Remove the blank cover-plate from the slot that you selected. Retain the screw so that it
can be replaced later.
4. Holding the card by the edges, align the connector edge with the PCI connector dock in
the server.
N
OTE
–
The connector dock in a 32-bit PCI slot is shorter than in a 64-bit PCI slot. Although
the adapter is designed to fit in either slot type, when installed in a 32-bit PCI slot, part of the
adapter’s connector edge will remain undocked. This is perfectly normal.
5. Applying even pressure at both corners of the card, push the card until it is firmly seated
in the PCI slot.
When properly seated, the adapter’s port connectors will be aligned with the slot opening, and
its faceplate will be flush against the server chassis.
6. Use the screw removed above (in Step 3) to secure the adapter in the PCI card cage.
7. Replace the server cover and disconnect any personal anti-static device(s).
8. Power the server on.
Once the server returns to proper operation, the adapter hardware is fully installed. You must
next connect the network cables (see page 2-4) and install the adapter driver software (see
Chapter 3).
!
C
AUTION
—
Do not use excessive force when seating the adapter, as this may damage the server
or the adapter. If the adapter resists seating, remove it from the system, realign it, and try again.