User`s guide

About this Guide
This guide describes the SGI 10-Gigabit (Gbit) Ethernet network adapter, shows you
how to connect the adapter to an Ethernet network, and explains how to operate the
adapter.
The SGI 10-Gbit Ethernet network adapter operates under the following:
• IRIX 6.5.23 plus required patches
• IRIX 6.5.24 plus required patches
• SGI ProPack 3 for Linux
You can use the SGI 10-Gbit Ethernet network adapter in addition to your current
adapter.
This guide assumes that you have general knowledge of Ethernet networks and the
system in which the adapter is installed.
Important Information
Warning: Never look into the end of a fiber optic cable to confirm that light is being
emitted (or for any other reason).
Do not use any type of magnifying device, such as a microscope, eye loupe, or
magnifying glass. Such activity causes cause a permanent burn on the retina of the
eye. Optical signal cannot be determined by looking into the fiber end.
Most fiber optic laser wavelengths (1300 nm and 1550 nm) are invisible to the eye and
cause permanent eye damage. Shorter wavelength lasers (for example, 780 nm) are
visible and can cause significant eye damage.
Use only an optical power meter to verify light output.
007–4669–001 ix