User guide

Installing and Removing Hot-Swap Hard Drives
007-5837-001 35
Figure 4-12 Inserting 3.5” HDD Carrier
Installing 2.5” Hard Disk Drive in 3.5” HDD Carrier
To install a 2.5” drive into a 3.5” drive carrier, use the following steps.
1. Remove the drive carrier by pressing the green button and opening the lever.
See A in Figure 4-9.
2. Slide the carrier out.
See B in Figure 4-9.
3. Remove the four screws securing the HDD to the carrier and remove the HDD or HDD
interface bracket (in the case where there is a 2.5” drive in place).
See C in Figure 4-10.