User guide

34 007-5837-001
4: Chassis Maintenance
3. Remove the four screws securing the HDD to the carrier and remove the HDD or HDD
interface bracket (in the case where there is a 2.5” drive in place).
See C in Figure 4-10.
Figure 4-10 Removing 3.5” HDD or Interface Bracket
4. Install the hard disk drive using the same four screws.
See D in Figure 4-11.
Figure 4-11 Inserting 3.5” HDD
5. Ensure that the connector end of the drive matches the backplane connector. With the lever
open, insert the hard disk drive assembly into the chassis.
See E in Figure 4-12.
6. Push in the lever to lock it into place.
See F in Figure 4-12.