Technical data

Regulatory Compliance Statement FCC-1
Regulatory Compliance Statements
FCC Radio
Frequency
Interference
Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the Federal Communications Commission
(FCC) Rules. These limits are designed to provide reasonable protection against
harmful interference in a commercial installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at
his/her own expense.
NetApp, Inc. is not responsible for any radio or television interference caused by
unauthorized modification of this equipment or the substitution or attachment of
connecting cables and equipment other than those specified by NetApp. It is the
user’s responsibility to correct interference caused by such unauthorized
modification, substitution, or attachment.
Laser Products
Statement
This equipment uses Small Form-factor Pluggable (SFP) optical transceivers, which
are unmodified Class 1 laser products pursuant to 21 CFR, Subchapter J, Section
1040.10. All optical transceivers used with this product are required to be 21 CFR
certified Class 1 laser products. For outside the USA, this equipment has been tested
and found compliant with Class 1 laser product requirements contained in European
Normalization standard EN 68025 1:2007. Class 1 levels of laser radiation are not
considered to be hazardous and are considered safe based upon current medical
knowledge. This class includes all lasers or laser systems which cannot emit levels of
optical radiation above the exposure limits for the eye under any exposure conditions
inherent in the design of the laser products.
NetApp, Inc. is not responsible for any damage or injury caused by unauthorized
modification of this equipment or the substitution or attachment of connecting cables
and equipment other than those specified by NetApp. It is the user’s responsibility to
correct interference caused by such unauthorized modification, substitution, or
attachment.