Technical data

Chapter 11: Specifications of the DE5600 Drive Tray 91
Table 69 AC Power Requirements for the DE5600 Drive Tray
DC Power Input
Nominal input voltages for the DC power source are as follows:
 Low range: –42 VDC
 High range: –60 VDC
The maximum operating current is 21.7 A.
DE5600 Drive
Tray Power
Factor
Correction
Power factor correction is applied within the power supply of each DE5600 drive tray,
which maintains the power factor of the drive tray at greater than 0.95 with nominal
input voltage.
DE5600 Drive
Tray AC Power
Cords and
Receptacles
Each DE5600 drive tray is shipped with two AC power cords, which use the standard
AC outlets in the destination country. Each AC power cord connects one of the power
supplies in the drive tray to an independent, external AC power source, such as a wall
receptacle, or to any uninterruptible power supply (UPS).
DC power is an option that is available for use with your DE5600 drive tray. For more
information, see "DE5600 Drive Tray Optional DC Power Connector Cables and
Source Wires."
Parameter Low Range High Range
Nominal voltage 100 VAC 240 VAC
Frequency 50 to 60 Hz 50 to 60 Hz
Idle current 2.96 A* 1.23 A**
Maximum operating current 3.03 A* 1.26 A**
Sequential Drive Group Spin Up 4.23 A 1.76 A
Simultaneous Drive Spin Up 4.43 A 1.83 A
System Rating Plate Label 7.0 A 2.9 A
* Typical current: 100 VAC, 60 Hz at 0.87 power supply efficiency and 0.99 power
factor. These numbers can vary significantly, depending upon the drives tested in the
particular configuration.
**Typical current: 240 VAC, 60 Hz at 0.87 power supply efficiency and 0.99 power
factor. These numbers can vary significantly, depending upon the drives tested in the
particular configuration.