Setup guide

Rackmounting an Optional IS2224 JBOD Enclosure
007-5922-001 21
– The mounting holes on the front flanges of the storage enclosure align with the
mounting holes on the front of the mounting rails.
– The rear edge of the storage enclosure sheet metal fits into the clip on the mounting rail
(reference Figure 2-10).
– The holes in the storage enclosure sheet metal for the rear hold-down screws align with
the captured nuts in the side of the mounting rails.
Mounting rail (1)
Mounting rail clip (2)
Partial view of the storage enclosure’s rear sheet metal (3)
Align hole in the storage enclosure sheet metal with captured nut in the mounting rail (4)
Figure 2-10 Sliding the Storage Enclosure into the Clip on the Mounting Rail
8. Secure the front of the storage enclosure to the cabinet. Use the two screws item (1) in
Figure 2-11 to attach the flange on each side of the front of the storage enclosure to the
mounting rails.