Setup guide

20 007-5922-001
2: ISS3124-RP2 Server and IS2224 JBOD NAS System Hardware Installation
Figure 2-9 Alignment Spacers on the IS2224 Mounting Rail
Use the Alignment Spacers to help properly place the rails into the rack and follow these substeps
to secure the rails in place.
1. Insert one M5 (12mm) screw through the front of the cabinet, and screw into the top
captured nut in the mounting rail.
2. Insert two M5 (12mm) screws through the rear of the cabinet and screw into
the captured
nuts in the rear flange in the mounting rail.
3. Tighten the adjustment screws on the mounting rail.
4. Repeat the previous three steps with the additional rail to install the second mounting rail on
the
other side of the cabinet.
5. With the help of another person, slide the rear of the enclosure onto the mounting rails.
6. The rear edge of the storage enclosure must fit into the clip on the mounting rail.
7. The storage enclosure is correctly aligned when the following conditions are met on both
mounting rails: