Setup guide

62 007-5923-001
3: ISS3112-RP2 NAS Operation and GUI Startup
Figure 3-5 Appliance Product Registration Screen Example
Configure the Primary Network Interface
To reconfigure the primary network interface, log in to the system console and execute the setup
appliance init command:
nmc: /$ setup appliance init
Next, you will be prompted to reconfigure the primary network interface. You may opt to choose
DHCP, if your environment supports it, as in Figure 3-6 on page 63. Or, you can set up the
interface statically (you will need to specify the device’s IP address, subnet mask, default gateway,
and DNS server addresses).
Tip: In most cases it is preferable to configure the appliance’s primary IP interface statically.
Follow your general local area network administration guidelines.