Setup guide

48 007-5923-001
2: ISS3112-RP2 Server, MIS JBOD and IS2224 JBOD NAS System Hardware Installation
8. Secure the front of the storage enclosure to the cabinet. Use the two screws item (1) in
Figure 2-29 to attach the flange on each side of the front of the storage enclosure to the
mounting rails.
Figure 2-29 Securing the IS2224 Storage Enclosure to the Rack’s Front
9. Insert one M5 (12mm) screw through the bottom hole of a flange on the storage enclosure so
that the screw goes through the rack’s vertical front rail and engages the bottom captured nut
in the mounting rail.
10. Repeat this process for the opposite side of the enclosure and tighten the screws after both
are properly aligned and in place.
11. Secure the enclosure’s plastic front-end caps by referencing Figure 2-30 on page 49 and
performing the following substeps:
– Put the top of the end cap on the hinge tab (1) that is part of the storage enclosure
mounting flange.
– Gently press on the bottom of the end cap until it snaps into place over the retainer (2)
on the bottom of the storage enclosure mounting flange.
Note: The left end cap has holes so the LEDs can be seen through them after it is attached to
the storage enclosure.