Setup guide

Rackmounting an Optional IS2224 JBOD Enclosure
007-5923-001 47
7. The storage enclosure is correctly aligned when the following conditions are met on both
mounting rails:
– The mounting holes on the front flanges of the storage enclosure align with the
mounting holes on the front of the mounting rails.
– The rear edge of the storage enclosure sheet metal fits into the clip on the mounting rail
(reference Figure 2-28).
– The holes in the storage enclosure sheet metal for the rear hold-down screws align with
the captured nuts in the side of the mounting rails.
Mounting rail (1)
Mounting rail clip (2)
Partial view of the storage enclosure’s rear sheet metal (3)
Align hole in the storage enclosure sheet metal with captured nut in the mounting rail (4)
Figure 2-28 Sliding the Storage Enclosure into the Clip on the Mounting Rail