Setup guide

Rackmounting an Optional IS2224 JBOD Enclosure
007-5923-001 45
1. Attach the mounting rails to the rack by performing these substeps:
– Make sure that the adjustment screws on the mounting rail are loose so that the
mounting rail can extend or contract as needed.
– Place the mounting rail inside the cabinet, and extend the mounting rail until the flanges
on the mounting rail touch the inside of the cabinet.
– Ensure that the alignment spacers on the front flange of the mounting rail fit into the
mounting holes in the cabinet (Figure 2–4 on page 2-6). Note that the front flange of
each mounting rail has two alignment spacers. These alignment spacers are designed to
fit into the mounting holes in the cabinet.The alignment spacers help position and hold
the mounting rail.
(1) Rack Rail Mounting Holes
(2) Adjustment Screws for locking the Mounting Rail Length
(3) Enclosure Mounting Rails
(4) Clip for Securing the Rear of the Storage Enclosure
Figure 2-26 Attaching the Mounting Rails to the Cabinet