Setup guide

38 007-5923-001
2: ISS3112-RP2 Server, MIS JBOD and IS2224 JBOD NAS System Hardware Installation
5. When all drives are in their correct slots, replace the top cover on the chassis and secure it
with its safety screw.
6. Move the chassis to the stowed position in the rack.
7. From the rear of the rack, move the chassis out backwards and repeat the above steps for the
rear of the chassis (StorBricks 5-9 for a JBOD).
Figure 2-19 Drive Installation in StorBrick Module Example
Check, Adjust or Install NAS Cables
The following sections are intended to help you check the NAS cabling, adjust it if necessary, or
properly install all cables in the case of a newly mounted system. You should always confirm that
all needed cable connections have been made prior to booting the Modular IS NAS system.
FT000104
0-2
FT000104
0-1
FT000104
0-0
FT000104
0-5
FT000104
0-4
FT000104
0-3
FT000104
0-8
FT000104
0-7
FT000104
0-6
sgi