Setup guide

12 007-5923-001
2: ISS3112-RP2 Server, MIS JBOD and IS2224 JBOD NAS System Hardware Installation
• Has the Tiltwatch indicator been removed?
• After removing the packaging, is there any visible damage?
2. Record any issues/problems (if applicable):
• Use the bill of lading to record any issues discovered during the inspection.
• Sign for the shipment after making notes on the bill of lading.
3. Report the issues to SGI:
Contact the SGI Customer Support Center (CSC) at 1-800-800-4744 (in the United States; refer
to http://www.sgi.com/support/supportcenters.html
for international numbers) to begin the
replacement process. Take photos of any damage and in your message, please send a brief
description of the problem to [e-mail]
. A coordinator will contact you about the problem.
Prepare for Setup
The shipping container for optional MIS NAS JBOD units should include a special D-Rack
“Stiffener bracket,” two sets of rail assemblies, two rail mounting brackets and the mounting
screws that you will use to install the system into a rack. The ISS3112-RP2 NAS server and
optional IS2224 JBOD storage enclosure do not require the “Stiffener bracket” used with the
heavier MIS NAS JBOD enclosures. Read the Warnings and Precautions section in its entirety
before you begin the installation procedure.
Choose a Setup Location
Leave enough clearance in front of the rack to enable you to open the front door completely (~25
inches) and approximately 30 inches of clearance in the back of the rack to allow for sufficient
airflow and ease in servicing.
Warnings and Precautions
Warning: Do NOT attempt to transport/move a fully loaded MIS NAS JBOD enclosure.
An MIS NAS JBOD enclosure can weigh up to 220 lbs (100 kg) when fully loaded. If the
enclosure must be moved, first remove the drives from the chassis. When lifting any of the
NAS enclosures, two people (one at each end) should lift slowly with feet spread apart to
distribute the weight. Always follow safe lifting practices when moving heavy objects, failure
!