Setup guide

10 007-5923-001
1: Introduction
Un-Racked NAS System Setup
If you need to install and configure the ISS3112 NAS hardware components and cables, go to
Chapter 2, “ISS3112-RP2 Server, MIS JBOD and IS2224 JBOD NAS System Hardware
Installation.” Continue the drive and cable installation using the subsections that follow in Chapter
2. Finish the system setup using the information in Chapter 3, “ISS3112-RP2 NAS Operation and
GUI Startup.”
Pre-Racked NAS System Setup
If the system chassis is pre-installed in a rack, locate the drive modules and install them using the
information in “Installing Drives in the MIS JBOD Enclosure” on page 36. System cabling can be
confirmed using the information in “MIS NAS JBOD Cable Guide & Chassis Location” on
page 39. When the system is ready to be plugged in and booted, go to Chapter 3, “ISS3112-RP2
NAS Operation and GUI Startup.”