User`s guide

Installing the Hard Drives

007-5653-001 29

Installing a Hard Drive into the Hard Drive Carrier

To install a hard drive into the hard drive carrier, perform the following steps:

1. Remove the two screws securing the dummy drive to the drive carrier (see Figure 4-2).

2. Lift the dummy drive out of the drive carrier (see Figure 4-2).

Figure 4-2 Removing the Dummy Drive from the Carrier

3. Place the hard drive carrier on a flat, stable surface such as a desk, table, or work bench.

4. Slide the hard drive into the carrier with the printed circuit board side facing down (see

Figure 4-3).

5. Carefully align the mounting holes in the hard drive and the carrier. Make sure the bottom of

the hard drive and bottom of the hard drive carrier are flush.

6. Secure the hard drive using all six screws (see Figure 4-3).

7. Replace the drive carrier into the chassis. Make sure to close the drive carrier using the drive

carrier handle.

Release button

rive carrier