User`s guide

Resetting the Card
007-5515-002 13
collisions:0 txqueuelen:1000
RX bytes:7937550911458 (7569838.4 Mb) TX bytes:7884939113514 (7519663.9 Mb)
Interrupt:225 Memory:d6000000-d6012100
eth5 Link encap:Ethernet HWaddr 00:E0:ED:13:25:66
inet addr:10.151.0.1 Bcast:10.151.255.255 Mask:255.255.0.0
inet6 addr: fe80::2e0:edff:fe13:2566/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:7482599270 errors:0 dropped:909 overruns:0 frame:0
TX packets:7649784657 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7925075464327 (7557940.9 Mb) TX bytes:7874740240254 (7509937.5 Mb)
Interrupt:210 Memory:d8000000-d8012100
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:168 errors:0 dropped:0 overruns:0 frame:0
TX packets:168 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:12270 (11.9 Kb) TX bytes:12270 (11.9 Kb)
sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
For more information on ifconfig, see the ifconfig(8) man page.
Resetting the Card
In the unlikely event that you need to reset the copper Gigabit Ethernet card, enter the
following:
ifconfig <interface> down
ifconfig <
interface> up
where interface is name of the interface. This is usually a driver name followed by a
unit number, for example, ifconfig eth0 down, for the first Ethernet interface.