Specifications

SG Series Programming SCPI Command Operation
M550129-03 Rev G 6-31
Command Description
SCPI
:VOLTage
Calibrate Output Voltage subsystem
N
:CALCulate
Calculates the value of the gain and offset for output
voltage.
N
:DAC <NR1>
Sets the output of the output voltage D/A converter.
N
:FIVEPOINT
<1|2|3|4|5>
(Ethernet only) Sets output voltage value for each
calibration point (1-5)
N
:FIVEPOINT?
(Ethernet only) Returns the entered values for 5-point
calibration.
N
:GAIN <NRf>
Sets the value of the gain for the output voltage.
N
:GAIN?
Returns the value of the gain for the output voltage.
N
:OFFSet <NRf>
Sets the value of the offset for the output voltage.
N
:OFFSet?
Returns the value of the offset for the output voltage.
N
:POINt <1|2>
<NRf>
Sets the voltage output calibration point
(1 or 2). The actual output voltage is measured with an
external meter.
N
:PROTection
Calibrate Output Voltage Protection subsystem
N
:CALCulate
Calculates the value of the gain and offset for output
overvoltage protection. This takes more than 30 seconds
to complete. Use *ESE 1 and a serial poll to detect the
completed operation.
N
:DAC <NR1>
Sets the output of the output overvoltage protection D/A
converter.
N
:GAIN <NRf>
Sets the value of the gain for the output overvoltage
protection.
N
:GAIN?
Returns the value of the gain for the output overvoltage
protection.
N
:OFFSet
<NRf>
Sets the value of the offset for the output overvoltage
protection.
N
:OFFSet?
Returns the value of the offset for the output overvoltage
protection.
N
:UNLock <string>
Sets the non-volatile memory available to store calibration
constants. The access string is “6867”.
:STORe
Stores the calibration constants in non-volatile memory.
N
:LOCK
Disables access to the non-volatile memory. Prevents
attempts to store calibration values. (Issue after
CAL:UNLock and CAL:STORe commands)
N