Specifications

Ethernet Configuration and Remote Programming SG Series Programming
5-8 M550129-03 Rev G
5.2.5 Configuration Switch
Use the DIP switch (will have either four or eight switches and is accessible
from the rear panel) to configure the power supply with the installed Ethernet
interface adapter. The following figures show the DIP switch configuration for
the Ethernet connection. On the Ethernet master, set the rear panel switch to
Remote On, and disregard all remaining switches.
Note: There is one of two types of DIP switches: toggle or rocker.
For toggle switches, the shading indicates the position of the toggle switch.
For rocker switches, the shading indicates the depressed side.
Figure 5-5. SG 8-pin Configuration Switch for the Ethernet Option
Figure 5-6. SG 4-pin Configuration Switch for the Ethernet Option