Specifications

Ethernet Configuration and Remote Programming SG Series Programming

5-6 M550129-03 Rev G

b. Click open Network Connections. (For XP, if in the Category

View, click Network and Internet Connections, and then Network

Connections).

c. In the Network Connections window, right click the icon for

the network adapter used to connect to the power supply,

and click Properties.

d. Find the TCP/IP protocol item under the Configuration tab

(for XP: find the item under the General tab), and click

Properties. Select Obtain an IP Address Automatically.

e. Click OK to save the change.

f. Click OK again to apply the settings to the network

adapter.

4. In Windows, click Start, and then Run…

5. In the Run window, type “ipconfig /release” and click OK.

6. Again click Start, and then Run…

7. In the Run window, type “ipconfig /renew” and click OK. Your PC will

assign itself an IP address in the Auto-IP range.

8. Power on the power supply and allow the power supply to perform its

initialization.

9. Identify the IP address assigned to the power supply by discovering it

with a

VXI-11 compliant discover program.

10. Continue by following the procedure in Section 5.2.4.

NOTE: When Auto-IP assigns an IP address, Web page connections will

time out after 5 minutes of inactivity, which requires logging in again.

5.2.3 Network Setup Using the Serial COM Port

1. Connect from the PC COM1 port to the power supply’s RS232 port

(see Figure 5-1 for port location) using a straight-through DB91 to RJ-

1 connector.

2. Have ready the IP address (e.g. 192.168.0.200) and subnet mask

(e.g., 255.255.255.0) to be assigned to the power supply.

3. Run a serial terminal program, such as MS HyperTerminal

. Set the

baud rate (bits per second) to 19200, data bits to 8, parity to none,

stop bits to 1, flow control to none. Establish the connection.

If you choose to use MS HyperTerminal

a. After inputting the above parameters, in the HyperTerminal

window click the disconnect icon and then the properties icon.

b. In the properties window select the Settings tab.

c. In the Settings window click the ASCII Setup button.