Installation guide

9
2. To configure a workstation drive partition (three are required),
begin by clicking Add in the Disk Druid Partitions window, which
brings up a popup window (see Figure 3).
Figure 3 Disk Druid Partitions Window and Popup Window
3. Select a partition type listed in Table 2 from the pull-down menu.
4. In the Mount Point field, type the mount point information from
Table 2 for the partition selected.
Note: If you selected a Linux swap partition type, the mount point
value is automatically entered in the Mount Point field.
L3Con_Install.fm Page 9 Tuesday, February 27, 2001 8:01 AM